AutoCAD Based (Calculations)
Total: 118
* On smaller devices swipe left to view hidden table data
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
|---|---|---|---|---|---|---|
| Ribbon/Toolbar (Software) | Button | Function | Error Type | Description | ||
| View (card-840) | Calculations (AutoCAD Based) | Start Autocalcs | Finish Area | None | AutoCALC is creating extra node points where there shouldn't be. In the image below, node 45 shouldn't be created as there's neither a flowing head nor a change in diameter at that point.
'extra node' 'extra ref point' 'extra reference point' 'refpt' |
|
| View (card-831) | Calculations (AutoCAD Based) | Start Autocalcs | None | Runtime Error | Caclulating Total Lengths... Runtime Error "13" Type mis-match |
|
| View (card-647) | Calculations (AutoCAD Based) | Start Autocalcs | None | Runtime Error | Runtime Error 7 Out of memory run-time error 7 run time error 7 Runtime Error 7 Miscfunc |
|
| View (card-599) | Calculations (AutoCAD Based) | Start Autocalcs | Calc Area # | None | Screen shows calcing Pump, then getting error 53. Pump calc not calcing Run time 53 |
|
| View (card-526) | Calculations (AutoCAD Based) | Reference Points | None | None | Bad ref point block Dialog box |
|
| View (card-510) | Calculations (AutoCAD Based) | Figure Head Area | None | None | Sprinkler blocks must have a Z coordinate equal to zero inches. Dialog box All |
|
| View (card-500) | Calculations (AutoCAD Based) | Reference Points | None | None | Missing a registry key. n/a Dialog box 50.2 |
|
| View (card-491) | Calculations (AutoCAD Based) | Start Autocalcs | None | None | • Two of the cores of the processor as well as "hyperthreading" were disabled from the factory in the Bios. • Dell Optimizer is not optimizing No error, just hangs while using 100% RAM. Usually around step 2.3 |
|
| View (card-482) | Calculations (AutoCAD Based) | Start Autocalcs | Pipe Schedule | None | Bad Registry Entry n/a Dialog Window HydraCALC |
|
| View (card-466) | Calculations (AutoCAD Based) | Start Autocalcs | None | Runtime Error | User is missing one or more required files n/a Runtime Error 53 Miscfunc |
|
